iStore 270L Heat Pump Hot Water System in Adelaide
Cost-Effective and Reliable Hot Water Solutions
CONSTANT, RELIABLE HOT WATER
Cost-Effective and Reliable Hot Water Solutions
The iStore 270L is a fantastic hot waters solution for larger Adelaide homes that require constant solar powered hot water
The iStore 270L is more than just a heat pump that provides reliable hot water. It also utilises pioneering air-to-air technology that can act as a battery alternative within your solar system. That means you save money!
Battery Alternative
The iStore captures excess solar energy that would otherwise go back to the grid or be stored in costly batteries. Instead, it turns this extra energy into hot water for your home, helping you maximize your solar power system and save money!
Lower your annual carbon emissions
We should all contribute to protecting the environment, and the iStore can cut your home’s carbon emissions by up to 4 tonnes every year.
Access Federal & State Government Incentives
Once your iStore system is installed, you can receive an incentive of up to $1,080 approved by the Australian Federal Government Clean Energy Regulator.
iStore 270L Heat Pump Pricing
Fully installed from $2600!
GET THE MOST FROM YOUR SOLAR SETUP
iStore 270L features
Battery alternative
Easy to maintain
Eco-friendly
400% efficiency
Low noise
Sleek design
SAVE ON RUNNING COSTS
Benefits of the iStore 270L
Heating water for your home makes up about 25% of the electricity costs for an average Australian household.
With the iStore, hot water heating usage drops by two-thirds compared to traditional electric or gas storage systems, and it cuts CO2 emissions by 4 tonnes.
By installing an iStore, you could save up to $1,000* annually on your energy bills.
NEXT GEN ENGINEERING
How It Works
1) The fan draws in air which contains heat, towards the evaporator
2) The evaporator mechanism converts the liquid refrigerant into a gas
3) The refrigerant is pressurised into a gas by the compressor
4)The water in the coil-wrapped tank is heated by hot gas inside the condensor coil
5) The refrigerant then turns back into liquid form after heating the water, which then continues back to the evaporator, where the cycle starts again
HEAT PUMP SPECS
Dimensions & Warranty
DIMENSIONS
| Height | 1955 mm |
| Diameter | 640 mm |
| Height to water inlet | 99 mm |
| Height to water outlet | 1194 mm |
| Hot water condensation | |
| Height to PTR valve. | |
| Height to anode | 1094 mm |
| Net weight | 135 kg |
WARRANTY INFORMATION
| Cylinder | 5 years |
| Refrigeration & electrical | 5 years |
| Valves or Accessories | 1 year |
STC VALUES BY ZONE
| Zone | 1 | 2 | 3 | 4 | 5 |
| STC’s | 20 | 18 | 24 | 25 | 25 |
